SRS Axleback System Stainless Steel Single (Civic 87-91 3dr/CRX 87-93)

Description

This stainless single axleback is the genuine SRS SUS 304 rear section, single outlet. SKU AXBS-CV88S-SS. Direct fit for the published Civic 87-91 3-door / CRX 87-93 applications. Pipe 60.5 mm, 115 mm tip. Gaskets and mounting hardware are in the box.

Stainless single axleback specs

Material: SUS 304 polished stainless (not the mild-steel sister SKU). Direct-fit axleback: 60.5 mm pipe, 115 mm tip. A stainless single axleback replaces from the rear axle back, not a full cat-back. Bolt it to the original points on a cold engine and torque evenly. Pair this stainless single axleback with SRS exhaust bolt and nut hardware. Dual-outlet stainless is the stainless dual axleback; mild-steel single is the steel single axleback. Genuine SRS from MCG Autostyling in Kells, Co. Meath, with fast delivery across Ireland. This stainless single axleback is listed for Civic 87-91 3dr / CRX 87-93. Confirm exact vehicles on the Fitments tab before ordering. Fitting is straightforward with basic hand tools and a set of ramps or a lift. Allow the system to cool fully before you start, and replace the flange gaskets supplied in the box rather than reusing old ones. Support the silencer while you thread the bolts so the rubber mounts are not loaded off-centre. After the first heat cycle, re-check flange torque on a cold engine. Keep the finish clean of road salt where you can. Measure the 115 mm tip against the bumper cut-out before you order.