Ford Focus Side Skirts – Zetec Style (Mk3 2013-2018)

Description

Ford Focus Side Skirts – Zetec Style (Mk3 2013-2018)

Zetec style side skirts to suit the FOrd Focus Mk3 4 door hatch back.

** FIBERGLASS KIT – ALWAYS TEST FIT BEFORE SPRAYING AS MODIFICATION WILL MOST LIKELY BE NEEDED!!

PLEASE USE A PANEL BEATER WHO IS FAMILIAR WITH FIBERGLASS!

Preparation

1. Inspect the Part:

Check for any cracks, imperfections, or damage during shipping. Minor imperfections are common and can usually be sanded or filled.
Test the part against the vehicle to assess the initial fit.

2. Prepare the Surface:

Clean both the fiberglass part and the car’s surface thoroughly with a degreaser to remove dirt, oil, or contaminants.
Sand the edges and contact points of the fiberglass part for a smoother fit.

3. Test Fit:

Dry-fit the part on the car without adhesives or fasteners to identify alignment issues or areas that may require trimming.
Mark problem areas with tape or a marker for later adjustments.

Adjustment

1. Trimming and Sanding:

Use a rotary tool, angle grinder, or sandpaper to trim or reshape areas where the part does not align properly.
Work slowly and check the fit frequently to avoid over-trimming.

2. Filling Gaps:

Use body filler or fiberglass resin to smooth gaps or imperfections between the part and the vehicle.
Sand the filler once it cures to create a smooth surface.

3. Reinforcement:

Reinforce weak or thin areas of the part with additional fiberglass layers if necessary, especially around mounting points.

Installation

1. Drilling Mounting Holes:

If mounting holes are not pre-drilled, carefully mark their positions during the test fit.
Drill small pilot holes first, then enlarge them as needed, using caution to avoid cracking the fiberglass.

2. Securing the Part:

Use the appropriate fasteners, such as bolts, screws, or clips, depending on the part and vehicle.
Avoid overtightening, as this can crack the fiberglass.

3. Adhesive Application (Recommended Technique):

For parts requiring adhesives (e.g., panels or spoilers), use a high-quality automotive adhesive or bonding agent such as tech7, tigerseal, windscreen bond etc.
Follow the adhesive manufacturer’s instructions for curing times and application methods.

Finishing

1. Primer and Paint:

Fiberglass parts often require a primer before painting. Use an automotive-grade primer and sand lightly between coats.
Apply automotive paint in multiple thin layers, allowing adequate drying time between each coat.

2. Protective Coating:

Seal the part with a clear coat for added protection against UV rays, dirt, and weather.

3. Final Inspection:

Check the alignment and fit after installation. Make any minor adjustments if needed.

Additional Tips

Professional Installation:

If you’re unsure about the process, consider professional fitting and painting services to ensure the best results.

Follow Manufacturer’s Guidelines:

Always consult the manufacturer’s instructions specific to the fiberglass part.

Regular Maintenance:

Inspect the part periodically for any signs of wear, loose fittings, or cracks, and address issues promptly.

Proper preparation and care will result in a flawless look and functional installation of your fiberglass car parts.

All parts MUST always be test fitted before spraying – Sprayed parts cannot be returned!!